Product Specification
The length of the Shuttering Magnet Lever is 1.3m, and the surface is sprayed with plastic.
Product Feature and Application
Optimized lever design
Long Handle: Provides enough leverage arm to allow the operator to overcome the strong magnetic suction with less force and pry up the shuttering magnet.
Prying head of the shuttering magnet lever
The prying head is usually designed to be flat and sturdy, allowing it to be easily embedded in the gap between the shuttering magnet switching indenter and the upper surface of the shuttering magnet for a better fit at the point of contact and effective application of force.
Product Packaging
FAQ
Q: When removing the shuttering magnet from the mold table, can it be tapped directly with a tool such as a metal hammer?
A: -Cannot, prolonged use of the hammer will damage the internal structure of the shuttering magnet, resulting in less time in use.You should use the removal tool that comes with the product, such as a shuttering magnet lever, to pry up the switch so that the suction between it and the platform is significantly reduced, so that the product can be easily and labor-savingly lifted.
-You can not use a metal hammer (if you must use a hammer, you should use a rubber hammer) to directly hit the switch pressure head, it is recommended to use the soles of your feet to press down and rely on the body's gravity to step down directly, should not be stomped down, to prevent slipping and injuries when stomping your feet.
Hot Tags: shuttering magnet levers, China shuttering magnet levers manufacturers, suppliers, factory, Formwork Accessories, Formwork System, High Quality Precast Concrete Magnet, Magnetic Shuttering System, Precast Concrete Magnet, Shuttering Adapters
